Hey guys,
I?ve cut a few cables to make up my own interface connector to connect my new 2010 DF90 to my Lowrance sounder ? I just want to double check what the pinout or wiring diagram is for the 4 pin square diagnostics plug on the engine (near the ecu) that i?m going to plug the cable into...
Hi,
Maybe once in every 10 trips i find I have a prob with my 1997 model DT25 where i'll pull start a few times, it'll cough momentarily and then it seems to flood - majority of the time she'll start after a few pulls.
When i finally get it started, smoke billows out for a short while then...
Hi,<br /><br />I have a suzuki DT25 with serial 02507-751213.<br />Engine is a 96 model.<br /><br />Just after a starter for it - tried brownspoint but their starter part number doesn't seems to be recognised anywhere.<br /><br />What part number(s) is a suitable starter ??<br />Will a hitachi...
hi all,<br /><br />i have noticed for a little while that my 97 model suzuki DT25 runs a little rough at low revs till she gets warmed up. on most occasions when warm she'll be fine and run smoothly.<br /><br />recently though she's started to stall at idle when i put pull the throttle right...
Hi gang,<br /><br />Hopped in the boat today and the trim switch on the control lever crumbled.<br /><br />Can someone tell me what the part number would be for this switch and the best way to go about replacing it (i'm assuming i can just get a new switch and fit it back into the control lever...
Hi all,<br /><br />I'm after an electric starter for my Suzuki DT25 1997 oil injected 2 stroke.<br /><br />Would someone happen to know the part number for it?<br /><br />Would be great to get a starter, i enjoy letting some of my older friends captain the little boat but some struggle a little...
Hi all,<br /><br />I'm located in Australia and am after a starter kit for a manual start Suzuki DT25. Motor is a 1996 model.<br /><br />They're a bit tough to get hold of and pricey here in Oz, can someone suggest an reputable marine retailers in the states for me to contact.<br /><br...
Hi all,<br /><br />I find that the pull cord on my 1997 DT25 suzuki often jams.<br /><br />Probably happens once every few pulls - i'll yank on the cord and it might budge a few inches then it'll lock up. <br /><br />i've gotten into the habit of start out softly and if it doesn't jam i give it...
Hi all,<br /><br />Just picked up an oil injected DT25 '96 model - being a 3 cylinder i figure that it's a detuned 30 (or higher).<br /><br />what is required to convert it from a 25 to extract the additional hp.<br /><br />many thanks,<br />storm.
Hi,<br /><br />I have a 96 model tiller steer johnson that seems to slip into reverse from neutral too easily. <br /><br />I have to be careful when shifting from forward to neutral because it'll just go straight into reverse.<br /><br />Shifting from neutral to forward seems firm but from...
Hi all,<br /><br />I just purchased a secondhand Johnson 25 hp "commercial" engine and have a few questions.<br /><br />Firstly, what is the year model - the information i have is:<br /><br />model: HJ25FPO<br />serial: G03989450<br /><br />Where should the anode be located - i can't find any...
