my brother in law is trying to convert his tiller to console but we cant find the bracket that holds the throtle and shift cables i think it mounts on two bolts of the intake if im not misstaken and i probably am but we cant find it in the parts fish if someone could help me out with a part # i...
i have a 15 foot flat bottom aluminum boat with a 30hp 3cyl yamaha and cmc trim it has a 13p solas prop at wot with just me alone i can run about 35mph and 5100rpm before it starts to pourpose. now with two people in the boat i can run about 33mph and about 5000rpm. i can only ge verry little...
i have a 30mshr yamaha that im converting to electric start via a junk motor i have a wire that is missing i think the red wire that comes out of the regulator and goes to a fuse then it has a plug in on it where dose it go i think it is the charging wire for the reg not sure any help would be...
i just bought a 97 3cyl 25hp evinrude i changed the water pump today checked the comp 105 all cyl i took the thermostat out found an old piece of i am assuming water pump rubber stuck in it is their something i should do to flush the motor or will it be ok and how do i flush it the service...
first I have a 15foot long by 48inch wide aluminun john boat it has a 2001 johnson 30hp with cmc tilt and trim I have a 10 1/4 X 13pitch prop i can hit the rev limiter with two people so i need to go up in prop about how much speed will i gain by doing this im at around 31 now and what prop do...
I have a 01 30hp johnson it has a 13 pitch prop its on a 15X48 aluminum boat i have a cmc tilt and trim it seems that my boat is cavitating i have the cavitation plate about even with the bottom of the boat cmc recomends 3in above the bottom if i do that i know ill have problems this weekend i...
ok i have a 01 25 johnson on my duck boat we run alot of shallow water and my fitting in my block where the tattle tale hose hooks will stop up with the tinyest piece of trash i am also hard on the little grates on the side of the foot. my question is if i change the size of the nipple and the...
i have a 2001 25hp with a 30hp carb. we are restricted to factory 25hp engines. i have a set of boyesen reeds orderd and was currious if their were any other tricks i could do to get some more power from it. i love this motor i dont have trouble in the shallow water trash like the suzuki 3cyl...
