Recent content by Rickf

  1. R

    Evinrude 50hp 4 stroke 1999, makes a squeeling noise at higher rpms

    Evinrude (Suzuki) 50hp 4 stroke 1999, starts and runs ok makes a squeal like a bearing seizing after 3-10 seconds, at higher rpms with muffs on, in gear and no prop, reverse in gear no no noise,, at rev limiter in neutral no noise, pull back to idle no noise, oil full, gear oil full, pp...
  2. R

    Evinrude 50hp 4 stroke, 1999, makes a squeal like a bearing seizing higher rpms

    Evinrude 50hp 4 stroke 1999, starts and runs ok makes a squeal like a bearing seizing, at higher rpms with muffs on, in gear and no prop, reverse in gear no noise,, at rev limiter in neutral no noise, pull back to idle no noise, oil full, pp stream so so, no indication or warning lights, any...
  3. R

    99 Evinrude 50 hp 4 stroke water pump failure, do I do Further exploratory surgery?

    The water pump failed and the ends of the impeller went into the engine, before I bought the boat. the water pump was replaced, with no engine flush, and run for several hours with no overheat. So it could have flushed itself out. Water flow from the tell tale is there, just is not real...
  4. R

    99 Evinrude 50 hp 4 stroke water pump failure

    Water pump impeller came apart, pieces through out motor, cleaned out tell tale ports, pulled thermostat, found 1 piece, blew air back through block ( lower housing is removed), nothing came out, Any ideas for getting the rest out, or plugs to pull to clean out, suggestions?? Thanks,
  5. R

    1999 Evinrude 50hp 4 stroke No start, need t/s guide and controls wiring schematic

    Help please, my manual does not show the controls and kill circuits for this engine, I have the full engine circuit, I have 12v to the hi pressure pump at the 15A fuse and power to coils and inj gray wire, No Spark, fuel pump does not run and no power to the coil and crank sensor circuits...
  6. R

    No start, No Spark, Evinrude 50hp 4 stroke, 1999

    Engine ran fine when stored 3 years ago, has compression, rolls over fine, no spark, has no power from ecu Connector D-1 to MAP, Crank Sensors, Cam sensor or anything else on that leg from the ecu, 2 engine fuses are good, have battery Voltage on B-5, What is the voltage supposed to be on...
  7. R

    Merc 228 84 model overheats at idle, ok at power

    I have a Merc 228 84 model that is overheating at idle but runs great the rest of the time. It is currently in the water so I pulled the water inlet hose off just above the water pump and started the boat, there is enough pressure that I can't hold my hand over the end, so am I safe to assume...
  8. R

    Johnson 200 Idle problem

    1994 Johnson 200, Model J200STLERK, This boat had sat for 3-4 years on a boat lift, compression 90 to 100 psi, done lync and sync per the factory manual, rebuilt all carbs, found floats stuck , jets loose, a lot of mud dobbers nests and some trash. Cannot get the idle speed up to run right...
  9. R

    HELP!! Force 35 overheating

    Pontoon boat and motor have been together for 25 years, older 35 hp Force long shaft 357f7a overheating at wot: quick run down started with would not run above idle, it backfired, ck reed valves ok, replace fuel pump, plugs, fuel and tank, compression at that time was 105 & 110, did a decarbon...
See more
Top