I'm trying to hard wire my motor to the control box instead of using the red connector plug because the wiring is all bad in the plug side of the motor. I'm having trouble matching wires to each other. Only two wires a yellow one going to the solenoid and a white one o the control box. I think...
my engine when it gets warmed up dark fluid that is black comes out from under the flywheel and when it cools it gets hard
also Ive noticed when it gets warmed up it looks like gas oil mix leaks from under the engine and runs down the shaft It has a rough run and doesn't idle good I have to...
my fish finder is not working it hasn't sense I got the boat but the original owner has passed and I have no manual to it there is a wire that doesn't go to anything that looks as it should go to something and also there is one going back to the sonar and then one going to the battery
sometimes...
my motor has an issue and I don't know what it causing it when I crank it it runs good but then wants to die after a few seconds and I can put the choke on and it will rev back up when I let off it and then it will start to go dead again and I can do the same thing and it work
any suggestions...
i have a few questions on my newly received motor im not to great with boat motors but im getting there
there is a nob on the front of the carburetor im assuming It would be to make it run less rich or more but im not sure does anyone know what it does
and also where can I get the gasket...
I have something on my motor that I noticed and I just got the motor so not familiar with it
it has a red nob on it and it is connected to the fuel line and carb thinking maybe something to do with the electric choke idk though
also some of my wiring has some corrosion on it should I replace it...
I have just aqired a old 1970 terrybass boat with a evinrude SPL 28 hp engine and it has a wired marking on the side where the fuel line goes and I was wandering what it means
and if anyone could help me out on finding the year of it
the model number is:E28ESLCCR
thanks
cr
I have just acquired a terrybass boat that was a good friend of mine who passed it is fiberglass blue and white but I know nothing about
his wife said he bought it a long time ago and kept it in the garage until last summer and he took it out to use it but got sick and never recovered
the card I...
a while back I think back in 2011 I bought a 1967 sears runabout boat from a fellow it was in sad need of restore it had been setting full of water for so long that the floor and transom had become weak so I took on the project of doing the floor first I checked all the stringers and they were...
I have a 1967 sears runabout fiberglass boat and im replacing the transom and ive always noticed some small hairline lines in the boat hull in a few places and im wandering what they are from and what I could do about them or if they are something to worry about
all the gelcoat is gone and im...
im replacing my transom on my boat and I messed a little piece of the back when trying to remove the wood and im wandering what would be the best way to go about fixing it ill post some pictures
thanks
cr
i have a 1967 sears runabout boat I a 1975 evinrude 50 hp sizzler motor but the problem is the two wheels that hook to the motor and turn it are needing to be replaced and I have no idea what they are called or where to get replacement ones and also I need to know what hooks all this to the...
I have a 14 ft sears runabout boat and it has a I believe a 20 transom but I also believe I have a motor with a shaft too long it is a 50 hp evienrude sizzler
ive been told it looks to long in my pictures but ive had it out quite a bit and it seems to handle great and smooth with no problems
my...