GOOD NEWS. . . . The PICTURE UPLOAD FUNCTION IS WORKING !!! The tech folks at the parent company have been able to remedy the issue. You can upload pictures once again. Thank you for your patience.
I found the problem after studying the wiring diagram. The purple wire which supplies 12 volt power to to the regulator via the switch was reading zero. I jumpered around it and it started charging.
20 volts ac is what I get from the two yellow wires coming from the stator and the voltage increases as the throttle goes up. I’m thinking something must be grounding out somewhere.
I have a 1988 Johnson 90HP motor with a strange charging issue. The stator is putting out 20 volts ac at idle, but I am only getting 12 volts at the terminal strip. Tach wasn’t working either, so I jumped the tach wire over to the stator side and it started working. This lead me to believe the...
I have a 1989 Johnson VRO 140 Looper that I am wanting to swap out with a 1990 Evinrude XP100. I am wanting to use the same controls from the 140. Will there be any difference in the wiring harness?
I have a 1989 Johnson 140 V4 and my water control valve has a slight drip to it. I have a new seal for it, but my question is how do I disassemble it to replace the seal. It looks simple, but I didn’t want to break it.
