I have an electric starter on my Evinrude E10freleu and the 19 years I have own the motor I have never used the manual pull start. I though it may be a good idea to try it out. I tried pulling the rope but it would not move. I looked at the lockout system and can?t see how it can move the...
Just put my 4th water pump in my 1997 9.9hp 4 stroke Evinrude 10FRELEU. I stuck the motor in a tank and started the motor. The flow from the pee tube was great at 3000 rpm but as I slowed down the speed the flow dropped off until there wasn?t any at idle. I ran it at 3000 rpm for about 10...
I had to replaced my fuel pump. I thought this time I would get the replacement parts instead of buying a new pump.
When I took the pump apart the two check valves were out of there housing.Not sure of why they came out I decided to go back to a new pump. Now 5 years later the pump is acting up...
It appears to me that there may be a problem with the fuel pump 435352. I had a problem with a pump pre 2009 that had the check valves pop out of their housing and it happened again in a pump purchased in 2009. It seems mighty strange that two pumps that I purchased both popped the check...
2009 I had to replaced my fuel pump. I thought this time I would get the replacement parts instead of buying a new pump.
When I took the pump apart the two check valves were out of there housing.Not sure of why they came out I decided to go back to a new pump. Now 5 years later the pump is...
Looking for a lay out of components in the 0435352 fuel pump . The part where the diaphram is located. there is about 1/2' spring. Are there 2 springs,one on each side of the diaphram ?? There is a smaller spring on the plunger. I have the shop manual and it isn't of any help. There is a diagram...
My 1997 4 stroke needs it 4th fuel pump. I have been looking in the internet and everybody list the part but then claims it is unavailable. I have tried the aftermarket and get the same results.I can't believe nobody was an replacement for this motor.Anybody know what is going on with this ...
I have a 9.9Hp 4 stroke and I'm on my third impeller since 1997. That seems to be pretty poor, specially since it is on a sailboat that doesn't get used that much. Not an easy replacement job either. Thoughts?
