Recent content by ronboonville

  1. R

    1990 evinrude 40hp tilt assist cable help

    found someone else asked this question in 2016 and thought no one knew how.
  2. R

    1990 evinrude 40hp tilt assist cable help

    Any tricks to replacing cable. Having difficulty hooking up.
  3. R

    Trailer spare tire

    The suggestion to use a donut came from a friend of mine. I have real spares for my pontoon and bass boat. This is for my little boat that I refurbished a used trailer for. Most of my trips are less than thirty miles round trip. I'm over sixty and have a lot experience at different things, but...
  4. R

    Trailer spare tire

    Need a cheap spare? Some temporary spares from cars fit. about $10 from a salvage yard. just check bolt pattern.
  5. R

    Hiawatha 3.6 flywheel and mag problem

    Hiawatha has a phelon mag. When I finally got the flywheel off I found the magnets had fallen off the flywheel. I need to glue them back on. I hate two part adhesives, but might have to go that way. I need suggestions to fix. I have 2 other scotts but the flywheels are different. I was going to...
  6. R

    Part number for sea king fuel pump kit

    Recently acquired Montgomery Ward 5hp. gg8977b same as 5d16b. 1959. need fuel pump part number, any help would be appreciated.
  7. R

    Nissan 90A fuel line

    Last season I had a problem with the primer bulb collapsing. The fuel tank vent is open, but I think my hose was too flexible and was collapsing where it makes a sharp bend. So I'm replacing the line. What size should I use? 3/8, or 5/16? Also I read an article that said the bulb should be...
  8. R

    Launching Pontoon

    Sometimes when launching our 24' pontoon with a 90hp Nissan someone has to push it some to get off the trailer. Of course backing in further would be easiest but sometimes it's more shallow. My question is would trimming up the motor help? I usually don't load passengers till after launching, so...
  9. R

    Position of pontoon in relation to axles question

    I have a 24' Nissan pontoon with a 90hp Nissan. Maybe 1986 vintage. It seems like the tongue weight is too much. There are no scales within 40 miles to check it. The trailer it came on is not the original and must have been for a smaller boat as I had to move the bunks out some for a good fit...
  10. R

    nissan 90a fuel problem

    sometimes after priming and starting i only go about 100 yards then it quits. squeeze bulb agin and runs ok till i stop for awhile and it does this again. can't tell if i have any air leaks and think i replaced the primer bulb and line about a year ago. i was going to replace the pump but...
  11. R

    Corsair outboards info needed

    A while back I found a couple of corsairs on a junk pile. One looked larger than the other. I'm assuming maybe a 7.5 and a 5 hp. I did not look at them very close and might go back when warmer. I think the 7.5 would use a remote tank and have shift. I can't find much info on the 5 hp. would it...
  12. R

    Towing with Jeep grand cherokee question

    I have a 24 foot pontoon on tandem trailer that I tow with an old 97 grand cherokee with the 4.0 six. I only go about 10 miles each way and it works ok. sometimes I use my 04 with the same motor, seems like less power. I'm replacing the 04 because it was totaled. I am looking at an 05 with the...
  13. R

    Yamaha 40 hp questions

    I found a starcraft supersport 16' with a 40 hp 1986 Yamaha outboard. I don't know anything about this motor. looks underpowered to me. good? bad? comments, thanks!
  14. R

    Paint color on 56' Mark 25 Hurricane?

    Under the black paint, under the gold paint I find a nice light blue, I think this is original color. Recoil and lower unit off-white? Badge on front yucky tanish ugly color? anyone have any pics?
  15. R

    Trouble starting in start position, points set too wide?

    My martin only starts when mag is almost fully advanced. Is it possible I have the points set to wide? It is hard to tell what is fully open when setting gap.
See more
Top