Current visitors

Home
Members

Scott Danforth's latest activity

Scott Danforth replied to the thread Mercruiser 4.3L - Stumbles at 3000RPM.

there is no mechanic in a can. seafoam is just naptha. nothing special. wont hurt....... wont help...... will make your wallet lighter

May 6, 2025
Scott Danforth replied to the thread leaking riveted starcraft ('82 MR180).

gluvit on tinnys...... there is also the stuff you can supposedly spray on a screen door

May 6, 2025
Scott Danforth reacted to Scott06's post in the thread Mercruiser 4.3L - Stumbles at 3000RPM with Like.

To the above would also take a look at the ignition components cap rotor wires and what do the plugs look like? I would also be leaning...

May 6, 2025
Scott Danforth replied to the thread Mercruiser 4.3L - Stumbles at 3000RPM.

how old is the fuel? when was the fuel/water separator filter last serviced? have you checked the content of the fuel filter for...

May 6, 2025
Scott Danforth replied to the thread Starter Not Engaging.

the seloc manual isnt worth being used for anything more than a knee pad. look at the pilot relay for the starter. follow the yellow...

May 6, 2025
Scott Danforth reacted to alldodge's post in the thread NO insects or spring birds this year. with Like.

They swarm around here all winter, still have lots now but not like it wa when food was scarce Have the usual red wing black birds...

May 5, 2025
Scott Danforth replied to the thread Thinking of trading deck boat for jet boat.

Im not big into the Yamaha jet boats. primarily from the extra fuel burn

May 5, 2025
Scott Danforth replied to the thread NO insects or spring birds this year..

bug splats on the windshields have been down for decades, significantly worse in the past few years insects are almost non-existent...

May 5, 2025
Scott Danforth replied to the thread Snapped seat bolt.

you know Ford is advertizing employee pricing right now.....

May 5, 2025
Scott Danforth replied to the thread Snapped seat bolt.

This is on your rusty but trusty truck? there should be a weld nut attached to the sheet metal. I would probably put in a few...

May 5, 2025
Scott Danforth replied to the thread Bayliner Floor Project.

its a roll of the dice. however I believe that in 2007, sugarsand used stringer tubs. doesnt mean that there isnt dead fish between...

May 5, 2025
Scott Danforth replied to the thread Crank driven vs block mounted raw water pump pros/cons.

must have done a few hundred heat exchanger setups in my prior life. you need to make sure the expansion tank is about 20% of the total...

May 5, 2025
Scott Danforth replied to the thread Bayliner Floor Project.

Not sure you will get into a newer boat, even needing a motor for only $2k. Boating is an expensive hobby. the last 4 years, the cost...

May 5, 2025
Scott Danforth replied to the thread Bayliner Floor Project.

define cheap? I would look on sites like boat trader, or visit your local marine salvage yard prior to using facetube market place...

May 5, 2025
Scott Danforth replied to the thread Boat budget question.

Just hope AC doesnt see this post......

May 5, 2025

Show older items

Home
Members

Top