Current visitors

Home
Members

Scott Danforth's latest activity

Scott Danforth reacted to tpenfield's post in the thread Vinyl Plank Flooring Installation Decision ??? with Like.

I might get an oven thermometer just to see how accurate it is. so far, it cooked the loaded nachos just fine😃

May 17, 2025
Scott Danforth reacted to redneck joe's post in the thread Vinyl Plank Flooring Installation Decision ??? with Like.

Agreed. That is why we upgrade to Bosch 800 series as we need new appliances.

May 17, 2025
Scott Danforth replied to the thread Costa Coat.

Jack trailer and boat up. Block boat with cribbing, lower trailer. Will cost you about $40 worth of 2x6's and a box of screws to make...

May 17, 2025
Scott Danforth replied to the thread Hole shot.

Or 15x15p. The issue is getting that large drag load moving. You need a bit of slip to get the RPMs up, and a low enough pitch to...

May 17, 2025
Scott Danforth replied to the thread Gas/water separator filter.

Ha Ha Sounds like when I splashed I had the steering rack installed backwards..... Right was left .. made for interesting first splash

May 17, 2025
Scott Danforth replied to the thread Vinyl Plank Flooring Installation Decision ???.

Joe, you assume it holds calibration. Ours is over temp one use, and may be under temp the next. We usually set the oven and adjust on...

May 17, 2025
Scott Danforth replied to the thread Sealing the U-Joint Bellows watertight on an OMC Cobra.

FWIW, Volvo uses permatex #3 between casting mating faces that live under water. I use the stuff for sealing gearboxs for work, I use...

May 17, 2025
Scott Danforth replied to the thread Gas/water separator filter.

Every 50 hours or once a year. Which ever occurs first So if you are only getting 16 hours a year, you change them with your annual...

May 17, 2025
Scott Danforth reacted to Paintman1960's post in the thread SBC breakin time with Like.

Roller , Performance build , good stuff, built and broken in many street builds. Just unsure on hours wise, on a boat. Using...

May 17, 2025
Scott Danforth replied to the thread Vinyl Plank Flooring Installation Decision ???.

Hope you have better luck with the stove/oven than we had. We have the same one. Get an oven thermometer because it will be off. We do...

May 17, 2025
Scott Danforth replied to the thread SBC breakin time.

Stock build or performance? Flat tappet cam or roller? If flat tappet, the first 20 minutes are critical for cam break in. 20 -30...

May 16, 2025
Scott Danforth reacted to Bondo's post in the thread Not so welcome anymore.... with Like.

Ayuh,..... Dam Newbies,........ :rolleyes::cool:;)

May 16, 2025
Scott Danforth replied to the thread Water in Oil.

Barr is one of the casting houses for Volvo Penta, Mercruiser, PCM and others aw well as Edelbrock. So they have pretty good stuff...

May 16, 2025
Scott Danforth replied to the thread Mercury 7.5 not peeing.

How deep is it in the bucket? Water needs to be 8" above the lower unit

May 16, 2025
Scott Danforth replied to the thread Water in Oil.

any cranking compression way above 150 is either water or oil in the cylinders, or a bad gauge. verify your gauge, however I bet if you...

May 16, 2025

Show older items

Home
Members

Top