Scott06's latest activity

  • Scott06
    Scott06 replied to the thread Prop Selection - Bayliner 175.
    That is pretty much right on what I did with my 3.0 boat. If your tach is accurate you are better off being slightly under propped like...
  • Scott06
    Scott06 replied to the thread Alpha Gen 1 Gimbal Transom Plate Swap.
    That is a Mc1 housing so should fit no issue in one of the pics is the transom housing serial number 5 xxxxx. You can put this in the...
  • Scott06
    Scott06 replied to the thread 5.7 Cast Iron Intake Manifold - Salt (‘raw’) Water Cooled.
    you can likely find a used fresh water one the dimesnsion listed for the marine edlebrock probably doesnt fit what you outline for...
  • Scott06
    Scott06 replied to the thread Alpha Gen 1 Gimbal Transom Plate Swap.
    this is listed as pre alpha, there are others listed on ebay as well...
  • Scott06
    Scott06 replied to the thread Required Safety Course.
    I’m in same boat family has a place in upstate NY but we live in PA. Somewhere on the NYS website it said that an out of state license...
  • Scott06
    Scott06 replied to the thread Timing check 350 5.7l Carb.
    yes some engines had no knock sensor. TB4 had no knock sensor at all. TB5 some engines have a knock sensor some do not. Ok makes sense...
  • Scott06
    Scott06 reacted to Big Gee's post in the thread 2016 Bayliner 175 Converted to All Electric with Like Like.
    Very interesting, I'm glad you posted this. Thanks.
  • Scott06
    Scott06 replied to the thread Puffing steam out vents.
    That’s good. Verify your exhaust is not leaking get it running do a couple oil changes to make sure it runs clear oil wise exhaust...
  • Scott06
    Scott06 replied to the thread Puffing steam out vents.
    Ideally you want to pressure test the heads too as often they crack at exhaust seat or jacket in salt wears through. If it were mine I’d...
  • Scott06
    Scott06 replied to the thread Puffing steam out vents.
    Your best bet is to pressure test the cooling system. Which isn’t hard to do and will confirm if you have a crack or other odd ball...
  • Scott06
    Scott06 replied to the thread Puffing steam out vents.
    Pressure test the cooling system see if it holds. of course better to do this before you tear it down. Did you see any cracks in lifter...
  • Scott06
    Scott06 replied to the thread Timing check 350 5.7l Carb.
    Here are some snips from the manual that me help you They may be out of order when I hit the screen shots page numbers are in lower...
    • IMG_0136.png
    • IMG_0135.png
    • IMG_0134.png
    • IMG_0133.png
    • IMG_0132.png
    • IMG_0131.png
    • IMG_0130.png
  • Scott06
    Scott06 replied to the thread Timing check 350 5.7l Carb.
    Take a picture of the module and post if if you have the wire on the ma I fold with a black rubber plug in it you have the T bolt 5 ...
  • Scott06
    Scott06 replied to the thread Spray of water from exhaust manifold above O2 sensor.
    as expensive as the manifold replacement is compared to it to a new or rebuilt long block if they leak water into engine …
  • Scott06
    Scott06 replied to the thread Bolts for water pump are rusting.
    Wire brush them and paint them with black rustoleum. likely the paint on them got nicked off when you changed it. What you are seeing is...
Show older items
Top