Current visitors

Home
Members

Scott06's latest activity

Scott06 replied to the thread Need different prop for pulling.

see what wot is with current prop then can make a reccomendation on how much to go down in pitch. Had a freind with a 4.3 MPI in their...

Jul 30, 2025
Scott06 replied to the thread Trailer bearing blowout. Need help with repair(s).

Eastern Marine in DE is another good site as well.

Jul 30, 2025
Scott06 reacted to rpatton's post in the thread Keep blowing my starter solenoid up. with Love.

I attached a picture of the solenoide and that wire that goes nowhere. Please do not crucify me on the jerryrig mount of the solenoide.

Jul 30, 2025
Scott06 replied to the thread aluminum prop comparison.

The blade shape , size , and rake are very different from a Revolution 4 so doubt it’s an attempt to copy. It just didn’t perform any...

Jul 30, 2025
Scott06 replied to the thread Problems starting after fuel filter/water separator change.

Disconnect it to test bad tach can kill the ignition Had a similar post on the GTO forum I frequent where one of the guys installed a...

Jul 29, 2025
Scott06 replied to the thread aluminum prop comparison.

I always had fairly good luck with Michigan and Mercury aluminum props, for what they are. Never used a powertech al prop, my brother...

Jul 29, 2025
Scott06 replied to the thread 1995 Alpha1 G2 bellows question(s).

Mercury and quicksilver are the exact same part. Quicksilver is their label outside their dealer network. Just verify it is an actual...

Jul 27, 2025
Scott06 reacted to alldodge's post in the thread Problems starting after fuel filter/water separator change with Like.

Assuming this was a blue or white spark (3/8 gap) and it repeated this spark several times as engine was cranking What we know; Have...

Jul 26, 2025
Scott06 replied to the thread Problems starting after fuel filter/water separator change.

Id defer to AD but would be thinking confirm injectors are opening does it cough if starting fluid is shot in there ?

Jul 26, 2025
Scott06 replied to the thread salt water in single cylinder.

Would think the last one is related to detonation

Jul 26, 2025
Scott06 replied to the thread Problems starting after fuel filter/water separator change.

At this point no you have enough fuel pressure that is should start. So at this point find out why its not starting. could be lack of...

Jul 25, 2025
Scott06 replied to the thread Problems starting after fuel filter/water separator change.

anti-siphon valve or clog in puck up tube, some have screes in them. I would check for spark first as there is fuel to the rail so...

Jul 25, 2025
Scott06 replied to the thread I have to do a gimbal bearing and bellows etc, I have a question regarding the shift cable. Merc A1 G1 3.0.

yes in theory. I would inspect it carefully , assuming its in good shape reuse it. This is what I did when changing my bellows 3 years...

Jul 25, 2025
Scott06 replied to the thread Problems starting after fuel filter/water separator change.

I think fuel pressure should be 40-43 psi not 30. I would assume it would still start with only 30 psi so this may not be the issue at...

Jul 25, 2025
Scott06 replied to the thread Mercruiser dies after getting on temp.

he is referring to the rotor inside the distributor. If it has cracks the spark energy can go to ground instead of through the cap/wires...

Jul 24, 2025

Show older items

Home
Members

Top