Scott06's latest activity

  • Scott06
    Scott06 replied to the thread Popped through the intake..
    Agreed the webber edlebrock is easy to tune if you have some background in it. If you have the factory webber put that on and see if the...
  • Scott06
    Scott06 replied to the thread What Is The Fuel Pressure Specs For 350;Mag MPI At The Rail?.
    you can always use an outboard tank or put the fuel line in a gas can temporarily to test. Last weekend I was trying to take the...
  • Scott06
    Scott06 replied to the thread aluminum prop comparison.
    if you have more slip quite possible you have some wear on the prop maybe some burn marks on it doesnt cost much to run a AL prop...
  • Scott06
    Scott06 replied to the thread Hesitation on 351W.
    I think either a 600 or 750 will work on a stock engine that size. When I bought my partial engine from michigan motorz in 2016 they...
  • Scott06
    Scott06 replied to the thread Hesitation on 351W.
    All carbs will have some type of enrichment system that kicks in as you get to WOT. Usually runs off vacuum that drops as throttle...
  • Scott06
    Scott06 replied to the thread Hesitation on 351W.
    Doubt you are running out of fuel supply -what do the plugs look like and are you sure your ignition is not missing or hitting a rev...
  • Scott06
    Scott06 replied to the thread Knocking when turning.
    more so than that I have seen lack of pertinent info in repair manuals, that coupled with more complex mechanicals drives some issues
  • Scott06
    Scott06 replied to the thread Knocking when turning.
    Obviously the OP is missing something, that is a good list of little chit that can turn a 10 min job into a curse fest, especially the...
  • Scott06
    Scott06 replied to the thread Popped through the intake..
    125 is good enough to run, and very even. seen much worse variation run just fine. As long as the plug seals the length of reach wont...
  • Scott06
    Scott06 replied to the thread 4.3 diesling.
    I've used it within the last 10 years so the technology still works... Decarbonizing definitely helped on my 3.0, I did this with...
  • Scott06
    Scott06 replied to the thread Fuel tank suction tube removal.
    Funny you say very fine hair, when i emptied the filter into a container you could see something that looked like texture in the gas...
  • Scott06
    Scott06 replied to the thread SX-A Gear Oil Screw.
    Obviously hadn’t been changed in a while what did it look like ? The old lube
  • Scott06
    Scott06 posted the thread Fuel tank suction tube removal in Volvo Penta I/O & Inboard Gas Engines & Outdrives.
    Helping a good friend boat is a 2002 Glastron 185, VP 4.3 carbed (2 bbl holley) SX drive. he has owned this boat 15 years very few...
  • Scott06
    Scott06 replied to the thread Running temp for 3.0 tks mercruiser suntracker 27 ft pontoon?.
    Yep just fine exactly what my merc with a 160 stat runs at, even in cooler water. I don’t think the alarm for overheat trips until 200...
  • Scott06
    Scott06 replied to the thread Knocking when turning.
    I wonder if the driveshaft , u joints and inout shaft snout of the drive are getting hung up in bellhousing.might try a different angle...
Show older items
Top