Recent content by sea king guy

  1. S

    taking motor out for test run

    morning, I have a 79'evinrude 55 hp, ,that has been in a covered garage for about 3 years, not used... its in good shape,,,,I used the muffs and got new fuel and sea foam, and hooked it up and it started up and idled fine. My question is, what else might I do, or look for,, I plan on taking it...
  2. S

    starter motor solenoid

    I had 1962 35 hp chrysler motor, and got a 55 hp evinrude, which I put on boat. when I attached all the controls and hooked up the wires to the starter solenoid, and when I turned the key on nothing happened... I ended up putting the postive wire from battery to the same bolt coming out of the...
  3. S

    tilt trim toggle and water muffs

    Good Morning,, solittle, thanks for the info, I hooked up the muffs, turned on the water and I did get the motor started, now I am really new to this, but the only water coming back out, came thru a little rubber tube at the bottom of the motor, ...a steady stream..... also when using the muffs...
  4. S

    55 hp evenrude outboard

    morning, I just got a 55 hp evenrude outboard that had worked fine up until 3 years ago when he put in his garage and hasn't used since. <br /> What kind of pre-run maintance do I need to do on this motor before I start it up to make sure I don't ruin anything? Brand new to this forum, and...
  5. S

    55 hp evenrude outboard

    morning, I just got a 55 hp evenrude outboard that had worked fine up until 3 years ago when he put in his garage and hasn't used since. <br /> What kind of pre-run maintance do I need to do on this motor before I start it up to make sure I don't ruin anything? Brand new to this forum, and...
See more
Top