Hello. I tested the engines with a hose at home. Now port engine is going over 2500 rpm in neutral and in gear, but the starboard is going over 2500 rpm in neutral BUT NOT in gear. Do you know where to look in that case. Do you think that in that case is really something related to the control...
Hello. I tested the engines with a hose at home. Now port engine is going over 2500 rpm in neutral and in gear, but the starboard is going over 2500 rpm in neutral BUT NOT in gear. Do you know where to look in that case. Do you think that in that case is really something related to the control...
I found some issues and I corrected. The transom cables (limit switch and position sensor for the Trim were disconnected on both engines. I check now and the alarms of Trim disappeared. One of the sensors outside was damage. I connected a variable resistor (50 to 150 ohm) to simulate the trim...
I found some issues and I corrected. The transom cables (limit switch and position sensor for the Trim were disconnected on both engines. I check now and those alarms disappeared. I'm steal dealing with the ignition Alarm. I'll put the boat in the water to check if now I can go over 2500 rmp...
Hello, I have a SeaRay Amberjack 290 with two MERCRUISER 5.0 MPI 2005 STERNDRIVE. Once I turn on the switch for Starboard Engine is beeping two times every minute. With VesselView is showing two alarms (TRIM ALARM and Ignition Circuit open or High Impedance). Engines are working perfect but are...
