its a new bulb and yeah the fuel pump is good. Sorry I thought I already posted about it. Yeah its low on fuel like maybe a quarter of a solo cup in the tank. Found that the gas gauge no longer working.
I think you are right i rechecked everything only thing that i found a problem with is the bulb. ether not enough fuel in tank to prime it or the hose is loose somewhere. just doesn't make since why would it start after the oil change
I know that but thats all I did was drain the gear oil and put fresh oil in and started the motor and now the motor revs high and it never did that before
I quit with this pos motor just going to get a johnson or mercury. Like how does it make since that motor idles fine with old gear fluid but when i drain it and put new fluid in start the motor it revs high and revs higher and higher the longer i keep the motor on. the old fluid was dark but no...
I was just wondering I used this stuff for my truck rear axle. its just been sitting in my garage. And this is the stuff I'm suppose to use in my engine doesn't look like much of a difference to me but I could be wrong why I figured I would ask first. Anything to save a buck right? P.S so no...
yeah I found the issue I'm still fairly new to outboards and never seen a circuit breaker with a reset button. @TheForcePower I was wrong the skeg was rebuilt before but they did a fine job hiding the rebuild that I though it was the original it is. the rebuilt has the machined hole for sliding...
Yeah I said the same thing when I first saw it. I took the lower end off to better confirm it and yeah there is a long machine made hole going from one side to the other. so when I put ear muffs on and turn on water the water go's from the vent looking things and right out the bottom of the skeg.
lol found a bigger issue think I just going to replace the lower unit since it seems the broken skeg has a leak really starting to hate force engines parts are somewhat cheap but whats the point if its just a **** made engine.
So today I was going to post a thank you to everyone who helped me on this journey to revive the boat as everything was ready to go. Got out to the lake put boat in water and boom another punch in the face from the boat lol. The issue is strange to me. no power to the key ignition switch, the...
Boat started up today and ran and idled fine I'm starting to suspect the problem was the gas in the old tank will post a photo here within the hour so yall can look and tell me what yall think.
I dont have a feeder gage only the digital caliper the measurement was with wide open gap they fully close if .010 is to much is there a way to adjust them without damaging the reed? I didn't do the flash light thing I just took off the reed because I don't have flash light and the one of my...
