The motor starts and runs well. Good water pressure but temps on the low side. Stumbles frequently between 1000 and 2000 rpm. There are two 1/8" diameter drain holes just above the lower anode. Both get plugged with sand grains (I ran aground in the north cut in the fog one day). I removed...
I have a 2000 Mercury 200 EFI Runs well but have a question on spark plugs. The sticker on the VST tank says use NGK BUZ8H. The Mercury manual says use NGK BPZ8HS-10. Both plugs work. I notice a bit of wear on the BPZ electrode after only 25 hours or so. Which plug is correct / preferred?
I have a single axle trailer that has a tendency to wear the inside shoulder of the driver's side tire. Is there a way to reduce this wear? I seem to use up a tire per season. Do I have a bent axle? Bad bearings? I don't think the camber is adjustable. With the trailer jacked up the...
I have a '97 Yammie 115 2 stroke that generally runs well. The only adjustment on the carbs is the pilot air screw with a nominal setting of 1.5 turns out from bottom. Is there a way to tune the idle setting other than by ear? There must be a way to dial the mixture in to the optimum setting...
Greetings<br />'97 Yamaha S115 TXRV - Temp indicator on digital gauge shows when I turn on the key. Had an over temp condition...seaweed...that caused the audible alarm to go off. Temp indicator on gauge did not light. Traced the wiring from gauge back to the stb side of engine. The orange...
