Recent content by smorris

  1. S

    35 hp ignition wiring

    The motor is a tiller steer model 35r76g with electric start. It has the following wires: large red and brown or purple-I know these are for the starter small red from hot side of coil two small black wires attached to blue wires attached ignition coils white wire from ground on starter coil...
  2. S

    '93 175 Vro ?

    Boat ran with vro hooked up. Thought I just had to unhook it! Thats twice I wish I didn't listen to myself (should've skipped the 1st wife). Plugged the vro and the motor would'nt idle or run well under a full load. Unplugged the vro and put the motor on fresh gas, ran great. Ezeke, thanks...
  3. S

    OOPS! 175 Looper

    1993 175 60 degree, new to me, rigging stage. A quick start. This site has been a huge help to my pure lack of boat knowledge. Thanks! Problem: I was working with the ignition, wiring a warning light. I have lost power to the engine. starter won't turn, choke won't close. The switch tests out...
  4. S

    Warning buzzer ?

    1993 175 60 degree evinrude. is the warning system live with 12 volts and do the switches, i.e. low oil, engine temp. and the rest, close this system feeding power to the buzzer. I don't know how else it would work. I have twins and both seem to be wired the same, but one has power at the...
  5. S

    '93 vro question

    I have twin '93 175hp 60 degree Evinrudes. I first mounted the motors and ran them with the oil injection hooked up. All seemed to run fine. Scared of the oil pump condition and not knowing the true history of the motors I descided to go premix. Plugged the oil intakes and unhooked the low...
  6. S

    poor running 175

    I have a 1993, 60 degree 175 that was recently mounted as a twin. The compression is consistant and initially the motor seemed to run well both at idle and high speed. I went through a period of fuel problems as I bought some mid-grade with water in it. This has been solved and the other motor...
See more
Top