Recent content by Stickalip

  1. S

    Lower end Shaft frozen

    I recently replaced the seals on the lower unit (top shaft). Also, a new water pump. Before putting the new pump on, I noticed the shaft will not turn. It does move a little in either direction but not much. I tried turning in upside down, still nothing. Could adding lower case gear oil help...
  2. S

    Removing lower unit house bearing?

    1994 Yamaha 130TXRS Near the water pump Im trying to remove the house bearing to replace seals. I removed the 4 bolts and the top seal came out easily but the other seal requires that the housing is removed. I have tried PB blaster and heating it a little. Is there a special tool...
  3. S

    1999 yami 115 water tube help

    One more concern. Here is a pic of the water tube it calls for... As you can see, there is 2 inches of tube before the curve(assuming that is where it feeds into the water pump) but the small piece of old water tube when removed is 4 inches long. I double checked the model TXRS130. rrrrr...
  4. S

    1999 yami 115 water tube help

    Hello, I struggled to drop the lower unit then found this. Looks like someone had used 4200 or some other sealant. Schematics show a long water tube with a bend in it, its hard to tell if the break is at the seal (where the sealant was) or farther inside making it possibly unreachable. Does...
See more
Top