I have one of those small forward only 2.5 nissans I use for my infaltable dinghy.
Lately it runs poorly. It starts quickly but begins to bog down after about 45 sec, if I choke it briefly and then un-choke it it will run great for about 25 sec. I end up having to play the choke continuously to...
I have a 20' Down East style Flat Bottom Round Chine Center Console (Eastporter 20) W/ 93 Mariner 90 HP. I dont know the pitch of the of the prop but I think it is
13 3/4" Diam.
15" pitch.
I rarely push the boat over 4000RPM, it just goes to fast.
Should I get a lower pitched prop to keep my...
93 mariner 90HP 3 cyl. The Trim moor finally crapped out. I've had no Down presure for two years. ( motor would spin but internal valve leak) so I am looking for a replacement set- up<br />Single-Ram Two-wire. I will eventually repair this one and have a spare.<br /><br />nrmahoney@cox.net
How can you measure the quality of your spark. Just because you see a spark at the plug does not mean that it is the right strength. Is there a procedure that allows one to measure the qaltiy of a spark?<br />I have a good quality volt meter and an induction AMP meter, is there some kind of...
My mariner 90 3 Cyl outboard uses Gapless plugs. NGK BUHW-2<br />I am interested in changing to a gapped plug, does anyone do this? and if so any recomdations on part #?<br /><br />Thanks
I accidently ran 5 gals at 100:1 instead of 50:1,<br />never over 3500 RPM mostly around 3000. Motor seems fine. I am using the correct mix now but have i done damage?<br />89 Mariner 90HP
