I may have this post in the wrong place and if I do I am very sorry. I have a 2003 Johnson 150. I'm draining the grease out now and need to buy the correct type grease to put back in the lower unit. Anyone have a recommendation at to what type, what weight and how much to put back in there?
I made a call to Crestliner to learn that the boards are 5/8" and its three layers laminated together. Well I can not find 5/8" at any of the lumber stores in my area. I can however find 19/32" board everywhere. From what I am learning the Nominal size is called 5/8" but to be more precise its...
I was able to locate the source of fuel leaking around the gasket located between the carburetor and the carburetor gas bowl on the bottom. This was last June 0f 2013. I parked the boat in the garage and decided to not mess with rebuilding the carburetor until after deer season was out. I...
I troll Down-Riggers for stripers so I'm usually at idle speed for hours. Every 6 to 10 minutes or so the Oil Light and alarm will go off. I can turn the motor off and immediately start it back and go another 6 or 10 minutes until it sounds again. At top speed it does not go off. The water...
Guys I have a 2003 115 Evenrude. Will the typical 80W90 Gear Grease that you buy at the local WalMart work in my Lower Unit even if it does not indicating "For Marine use" ?
