The trim motor works fine, you can hear it going. The seals I think are bad. You can raise the motor with the assistance of some lifting while using the switch, but then the motor just goes right back down again, and rests against the rams. If boat is underway, then rams go in and motor is at...
I have a 89 evinrude 225hp on a 21ft daytona, the tilt & trim motor will not go up. I was running and the motor just went all the way down, and would not come up. There is fluid leaking from the bottom right support rod/piston. It is leaking around the outer ring, is that a seal problem, and is...
