Just finished rebuilding the engine, the engine started right up and runs very well, but I have a water leak somewhere at the mid case to power head junction. The water indicator is shooting a good stream, and the engine is circulating water. No leaks at the thermostat housing. No leaks above...
Does anyone know if the GLM aftermarket head gaskets need an additional gasket sealer applied? The GLM gaskets are shiny which I assume is an impregnated sealant?? The factory OMC service manual calls for coating both sides of the head gaskets W/ "OMC Gasket Sealing Compound Since these are not...
Recently had my '94 Evinrude 115 bored .030 oversize, I believe the ports need a new chamfer but don't know what size the chamfer should be. Just looking for a general place / idea where to start on a dimension, break the sharp edges with say .01 or .02 chamfer?? Appears like this could be quite...
Hello all new to this forum, I've had this motor for 3 years now & it's always been very hard to start. I had not used it much this summer, but today was beautiful (low 70's) so I took the boat out & could not get it started.<br />Would sputter & die, the starter eventually got so hot it burned...
