Recent content by svb165

  1. S

    06-5.7 mpi mag starts,, stalls, starts stalls. ran fine last fall

    yes the filter WAS pretty dirty even down into it a bit. I pulled it. as far as pressure maintaining 40 I will check that again tomorrow. I left the gauge on for a couple of hours today while I was running errands and it dropped to about 31 from 38. that didn't seem terrible for 2...
  2. S

    06-5.7 mpi mag starts,, stalls, starts stalls. ran fine last fall

    Yes I need to have it scanned for sure. I replaced the iac module and it iis better. it still stalls out and needed to be re started and revved a little, then it tryyys to idle. I got my hand near the open intake and cut a little air entering the TB, it stalled immediately. it did idle...
  3. S

    06-5.7 mpi mag starts,, stalls, starts stalls. ran fine last fall

    Thank you for the link. I'm tryyyying to make it to Boston for "sail 250" this weekend so I'm trying the Ford part today. from all I've read its identical. ? much like the fuel volume control valve the NR-1 is used in many applications and not 200$ thru auto parts dealers.
  4. S

    06-5.7 mpi mag starts,, stalls, starts stalls. ran fine last fall

    Thanks that's what I was reading also. there's no movement tho.. what's your take on using the Ford replacement module??
  5. S

    06-5.7 mpi mag starts,, stalls, starts stalls. ran fine last fall

    I just removed the IAC module, its pretty spotless inside. when I turn the key on while its plugged in holding the valve, it does NOT move at all. there iS power getting to it. this motor has about 100 hrs at most
  6. S

    06-5.7 mpi mag starts,, stalls, starts stalls. ran fine last fall

    yes it is mechanical although the parts look up pages I use(merc) shows a second fuel pump near the filter, for serial # over 330000 this does not have one. just the cool fuel pump.
  7. S

    06-5.7 mpi mag starts,, stalls, starts stalls. ran fine last fall

    OW359972 as I said it ran great all last season. it did start hard the last couple times I had it out but that's it. this is why I went and did the fuel pump and regulator. this is a cool fuel system also.
  8. S

    06-5.7 mpi mag starts,, stalls, starts stalls. ran fine last fall

    I can ,, somewhat. if I pump it some it will rev up, then it wants to quit again if I let off the throttle. or it will poof pop and want to quit..
  9. S

    06-5.7 mpi mag starts,, stalls, starts stalls. ran fine last fall

    I just replaced the fuel pump and regulator and still the same. 43 lbs while it primes 39ish sitting. could this be from a bad IAC valve valve??
  10. S

    new engine overheats

    OH and thanks for the input. it has been greatly appreciated.
  11. S

    new engine overheats

    well I thought I'd stop in and say I found the issue. ,,,,,,,when I bought new manifolds they gave me the wrong manifold gasket set. it wasn't allowing enough water to flow out of the motor. pretty basic but what a pia tryna find the issue thinking it was rebuilt correctly before it was put...
  12. S

    Accumulated parts I'd like to part with.

    Like many of you I'm sure,, I have accumulated a bunch of parts I dont need and listing and selling in these forums isn't allowed. is there a site y'all might recommend to list them for sale. not ebay or Craig's list, maybe an actual boat site.
  13. S

    Mercruiser 2.5 ticking sound

    I had ta ask
  14. S

    Mercruiser 2.5 ticking sound

    DIZZY ??
  15. S

    new engine overheats

    thanks yes I'm looking at everything at this point. it is the same housing listed for both 5.0 and 5.7 with the single point drain system. same stat too. 160*
See more
Top