I have a 1990 Johnson 150 GT with OMC controls. I need to replace the trim switch that is mounted in my throttle lever. I took the box off, loosened the allen bolt in the middle, and tapped on it like the manual says. The throttle lever didn't move. I tapped fairly hard on it, but still did not...
Just put a A Turbo 1 prop on my 1990 Johnson 150GT. It came with a Guardian SQ-Lok hub and all the hardware including a new thrust washer. The prop seems to fit fine, but it does not seem to go into the lower unit as far as the original. There is no gap between the lower unit and prop, just is...
I assume it's aluminum but am not sure. The only numbers I could find on it is the diameter and pitch: 14 1/4x21. It's on a 1990 Johnson 150GT. What brand of stainless prop do you guys recommend and where should I buy it? Any special tools needed for install?
I have a 1990 Johnson 150GT with the oil injection removed. Due to some gas running out of the carbs with the engine tilted up when transporting I would like to run it out of fuel when I put it on the trailer. I can't seem to find a quick disconnect that will mount into the lower engine case. So...
I have a 1990 Johnson 150GT model # J150STLESB I want to replace the fuel line from the tank to the engine and also replace the primer bulb with an oem, and place it outside closer to the engine instead of under the seat by the tank. My question is when I go to boats.net or any other website...
I have a 1990 Johnson 150gt and am looking for a manual. Would this be a good one to buy?
http://cgi.ebay.com/ebaymotors/1990-Johnson-85-115-150-175-service-repair-manual_W0QQitemZ260542575666QQcmdZViewItemQQptZMotors_Manuals_Literature?hash=item3ca98c3432
Any other recommendations?
Just bought a 1990 Ebbtide Campioni 180. It has two drain holes right next to each other. One has threads and he included a metal plug that threads into it. The other hole is plastic and looks like the bilge pump hole on the side of the boat. What kind of plug do I need to get for this? What...
