Recent content by sybarite

  1. S

    Recommended Spark Plugs?

    What is the recommended spark plugs for a 1988 85hp Force outboard. It is a 3 cylinder. The id plate has been removed from the transom bracket, so I have no model numbers or serial number. Thanks for any help, SY
  2. S

    HELP? Locating Model #

    I have a 1988 Force 85hp. I am trying to locate my model number. There is a white label on the portside of the transom bracket but no numbers. It is NOT a metal plate. On the transom bracket, on both sides(port & starboard) is the numbers 75-2 stamped on the transom bracket. 63is stamped on the...
  3. S

    ? Remove Tilt Piston Shaft

    What is the best way to remove the tilt piston shaft? I have to replace the tilt cylinder band, because the fitting broke off. I have a 1988 85hp Force motor with tilt & trim. I have tried to knock the shaft in with a punch and hammer but the tilt shaft does not move. I have tried the same...
  4. S

    HELP? wiring ignition switch

    I have a 1988 85hp Force/Chrysler. I replaced the ignition switch with a new Marpac Evinrude/Johnson ignition with push to choke. When I purchased the motor the old ignition had no key and I got the ignition switch from a friend. The problem is that it will not start from the ignition switch. I...
  5. S

    Stuck in Gear?

    I have a 1988 Force 85hp outboard. Before I replaced the control cables and control box, along with a new ignition switch, I could crank the motor. Just purchased the motor a couple of months ago. Control cables were no good that came with the motor, so I bought new cables and replaced the above...
  6. S

    Trim/Tilt Fluid?

    I have a 1988 Force 85hp with power trim and tilt. I have replaced the tilt cylinder sleeve, my question is- can I replace the fluid in the trim/tilt unit with mercon transmission fluid? I read somewhere on the internet that this can be done or to use 30 weight SAE non-detergent oil. Which one...
See more
Top