Re: Drive leaks down, trim system does not hold pressure-Model 290, PowerTrim EARLIER
Thanks again RRitt!! So turns out replacing the check valve seals improved it but now I (still continue to) have another issue. The unit will not trim out / up under load. Seems to me it's bypassing via the...
Re: Drive leaks down, trim system does not hold pressure-Model 290, PowerTrim EARLIER
Thanks RRitt! Great info! I just want to be sure I am "prying" the right part... The check valves are on either side behind the internal snap retaining rings, correct? As in this pic? ----->>>> If so I...
Hi There - Saw the Sticky on the bulletin related to "Drive leaks down, trim system does not hold pressure" - Bulletin 44-5-2A. It indicates it applies to "All DP-290 with Power Trim", however the pump in the picture shows the later model and I have the "earlier model" as pictured in the 2...
Any advice is appreciated.
E225FPXSSC
Motor runs excellent.
New water pump (regular maint only) about 5 hours ago
1st 5 hours pump worked great
now losing pressure - as 15 psi is reached i get a sudden drop to 5 or so psi
under 2k rpm OK - if i let it idle and regain pressure
Temp climbs on...
Does anyone have a copy of the Service Bulletin that addresses install procedure for new Ficht Injector? The new injector came with a disk and said to launch the Go.exe program but also said to refer to the Service Bulletin - which it did not come with. I installed it with the disk and can see...
Good Afternoon! Would any dealers out there mind pulling service records for my motor Serial #G04772828 / Model # E225PXCSSC?
The reason I'm asking is the EMM failed and I'm curious to see if it's ever been replaced and am curious to see any other history.
Thanks in advance! I called BRP but...
My 2000 225 Ficht RAM was running great and stopped running suddenly. The engine did not overheat and there were no codes set.
EMM did not power up - did not activate fuel pump - starter would not turn without manually applying power to solenoid. Diagnostic software would not communicate...
Is there a way to 'bench test' a Ficht Fuel Injector - year 2000 - 225 HP?
Reason I ask: Engine was sitting for a year. I don't have the diagnostic software and seems engine is not firing on all 6. Timing light verifies ignition on all 6 spark plugs. Have not tested the injector wires yet...
Greetings!
I have E225FPXSSC 2000 225 Ficht Ram which has FICHT Fuel Circulation Pump P/N 439712 and need to replace. (Voltage for 10 seconds at the pump when key turned to ON but no pump noise and no pressure at fuel rail) Does anyone know if it is interchangeable with newer P/N 5004429? I...
