Recent content by Teaki

  1. T

    Power trim problems

    I was able to get back to my project outboard. Disconnect both cylinders from engine and open the release screw. I broke the tubing loose to the port cylinder. I was able to move the starboard ram freely by hand. The port ram moves from closed toward open only 3” freely than stops to a hard...
  2. T

    Power trim problems

    When I’m able to get back to it I will see what I find. Thanks for your advice. I’ll post the results if I find anything.
  3. T

    Power trim problems

    A picture is worth a thousand words thanks just need a direction.
  4. T

    Power trim problems

    Yes both cylinders look identical. Starboard side is trim so port side must be tilt. Tilt is the cylinder not moving and Strains once trim, reaches, High Point
  5. T

    Power trim problems

    I have a 1984 50hp that has been in storage for 25 years. As getting it back in service the power trim is not working properly. The trim will go all the way in up and down position but when it gets to tilt it strains but will not move anymore. It has a cylinder on each side of the engine. I...
See more
Top