GOOD NEWS. . . . The PICTURE UPLOAD FUNCTION IS WORKING !!! The tech folks at the parent company have been able to remedy the issue. You can upload pictures once again. Thank you for your patience.
OK I understand my 89 110 Rude only requires 89 octane but I can get NON ethenal 89 or 91 octane. My question is where I don't get to run my boat as often as I would like, does fuel lose octane as it sits so buying the 91 be safer as to knocking.. And does the 91 burn slower so the 89 would get...
I installed monster tabs on my new to me 89 fiberglass bass tracker and when I drilled the holes in the transom on one side water leaked out. This was only on the right side and only from one hole but I now wonder if, or how much water is in there. The area seems to be glassed in. Should I...
I give up on these wires I have to put together......One started the foam under my engine cover on fire last weekend after it came apart and sparks were flying everywhere. Trying to assemble these wires (even with the recommended liquid) is NOT in my ability. where can I buy four 9 inch wires...
OK what should I run this rebuilt engine at ???? I was told to prop for 5800 rpm because this engine is high performance and higher rpm will keep carbon build up to a minimum BUT my manual says 4500-5500....what would you prop for .thanks
is that tru I'm running 17 pitch prop on an 18 foot bass tracker holeshot is a little slo should I try to 1 should I try to 15 pitch thank thank you
Right now i am getting 5200 and was told 5800 would be better for the motor
Finally have my rebuild 110 running good but it will not restart without having to open the throttle a bit, then it idles fine. I have installed Boyesen reeds and did there recommendated air jet change but still will not start without cracking open the throtlle and that is a pain. Now I cant...
A few years ago I had a dealership Link and Synk my outboard and the guy checked timing at idle and then with the timing lever disconnected, with the Outboard idling, moved the timing lever to max. advanced to check max timing. This is similar to the reeves timing but I dont think he took into...
I had a mechanic time by
I had my motor time end is this the same as doing it static with the moto is this the same as doing it static with the motor of
My rebuilt 110 seems to foul a plug and then pick it up at wide open. I am now running 50-1 after a breakin of 36-1. I have replaced the coils and plug wires and have tried both type of plugs recommended for this motor with the same result. wot is 5-5100. is this too low????
just rebuilt a 110 evinrude and I removed the vro system so I broke the engine in on 36-1 oil. I also installed boyseen reeds during the install and the roller that was in the slot for the timing lever seemed to have either wore down or the outer part,if there was one was gone so I picked up a...
