Recent content by theduckman

  1. T

    Carb problems

    I'm not sure if it's my adjustments I'm doing to the carb or what. But I am trying to tune up an old 1967 wards Seaking 6. Sometimes it will run for a few mintues in full throttle and sometimes it will run for only a few seconds. But when it starts to die down, I can pull the choke in and out a...
  2. T

    Lower unit problem

    I'm trying to remove the bearing carrier of a separate lower unit I bought and exchange it with one I have, but can't seem to get it off... any ideas/info?
  3. T

    2 questions!!!

    Re: 2 questions!!! heres the carb, if someone could explain what screws do what. the pic is sideways
  4. T

    2 questions!!!

    Does anyone know how I can get ahold of a 1967 wards SeaKing 6 model #VWB27906A. The other question is how do you adjust the carb, there's a top screw and a screw on the side. I had it running with the throttle up a little so it wouldn't die, I turned the side screw and now it will idle but...
  5. T

    Over Heating problem

    I have a 1967 Wards Seaking 6, (that i'm still looking for a propeller, shearpin and nut) but it runs... I can run it for a few minutes then the lower part gets really hot and I noticed no water coming out of the hole where i believe its supposed to. I took off the lower unit and checked the...
  6. T

    Impossible prop to find

    I'm looking for a 1967 Wards SeaKing 6 hp outboard propeller with shearpin and nut on a smooth shaft, which turns out has become impossible to find? Does anyone know where to find one?
  7. T

    (Wards SeaKing 6) Question??????

    I have a couple questions on a motor that was given to me, the model # VWB27906A and the serial is 76X13082. What year is this motor? and possibly who made it? Also, I stuck it in a bucket of water and cranked it, and got it to run, but I didn't notice any water coming out of the upper hole...
See more
Top