where can i find parts for this motor please post link i have not tried to fire it up yet but will be soon and what is the oil to gas ratio mix 16 to 1
and please point me to any and all info on it model number is 571.58761 and thank u in advance
i just got a little evinrude motor guy that i got it from said it was a 5 hp but not sure of year ether all i could find is the serial number which is 3034-03729 can you guys help me out please
i have my strings and new transom wood covered in poly resin but i need to know if i can use epoxy to put transom in and adhere to outer transom skin and the to put woven roven on hull to stingers
well i got the boat and trailer few next to nothing and it is in good shape as far as the fiberglass is concerned but the stringers and transom are in the process of getting redone but have a few ? this is my plan of action as follows i will have boat all grinded down ready for the new stuff to...
istead of using wood to replace my stringers can i use composite deck wood for it the reason is it doesnt rot thought it might last a lot longer and it is supposed to be superior to wood and i can get it at lowes
i have a 1970 55 hp Chrysler 557ha motor and it ran fine before put up for winterizing. but now it turns over but wont start up. did the checks such as spark, fuel and such it acts like it doesn't have enough battery power to crank over fast enough. the batt is brand new and i noticed that...
i have the above troll motor it is bow mount tiller handle it has three wires for batt hook up a red a white and a black wire i/24 volt switch on it to i want to run it 12 volt which wire do i use red or white for 12 volt i know black is ground
i have the above trolling motor but was needing a schematic for the control board and the foot pedal board or a way to test them to see what is wrong the foot control will turn motor left and right but will not turn motor on or adjust speed i have put a toggle switch on it and the motor is ok...
i have three batts in my boat one is starting and two for trolling and eletronics and i may buy a switch but need to know if my shumacker charger will charge all of them at the same time with the switch set at both the two batts for trolling and electronics are wire for 12 volts so i have longer...
i drained it and it is milky brown what should i check and can i get new seals and gaskets for a 1970 55hp Chrysler 557ha i have already determined that i have to put in a new water pump impeller but need to know if i need both of the gasket sets that iboats list for it or just one but didnt see...
OK my motor started a month ago with no probs but now when i go to start it it turns over but wont stay running well this is where it gets interesting if i hold the key over it starts and stays running the starter gear drops back down and you can throttle it all day long as soon as i let off the...
my harnes has 4 wires at the helm that are not hooked up and need to know where they go or what they go to
purple??
white ??? tach i think
orange??? temp gauge i think
black ??? ground i think
need info asap wiring things up now and need this info asap
my boat had 10awg wire from rear to trolling motor and then 10awg from rear to helm and then 10awg from rear to auxiliary switch panel i am going to put all new wire in and need to know if 10awg wire will be ok to replace the old 10awg wire the trolling motor is 12volt and if it is what size...
