i checked the shaft end play on my upper gear assembly and i was able to get .004 inch between part of the nut and bearing but it would not slid freely all the way around, in fact i went clear down to .001 inch and it still would not slid freely all the way around. I could not get .005 inch...
My rear seats backrest needs replaced. The backrest is hinged for opening to gain access to the steering linkage and to the electro-mechanical lift and other things at the rear of the motor. It is paded along the top. Does anyone know where i could find a new replacement. Also does anyone know...
i am trying to order a new tilt motor for my 87 bayliner capri volvo penta aq131a 275 drive. can anyone give me the part number i need to use, i cannot read mine. the volvo parts says it is a 850834 but when i search this part number on line i get a -3 on the end of the part number on sites like...
i have power up to the lift motor but it does not actuate the lift. I have 12v when switch is put to up and 12 v when switch is placed in down. Does the boat engine have to be running for this to work?
what can i do to make sure my heat exchanger is working properly? I have it removed from the motor and i would like to make sure it is functioning properly before i install it and run the motor. I just had motor repaired for leaking head gasket. How do you determine if a heat exchanger is...
i am trying to find the intake manifold gasket for my AQ131A by itself and not in a kit. i have looked on volvo penta parts and ebasicpower websites and cannot find it by itself only in kits. anyone know how i can get just the intake manifold gasket and not the whole kit?
is electro mechanical lift suppose to raise and lower the drive? Can someone explain how this raises and lowers the drive because all i see a plunger looking thing (see photo). Please explain this to me because my repair manual does not show it it only talks about hydraulic cylinders which i...
