Recent content by TpaPaul813

  1. T

    Mercury 15hp OB

    So I just got a 16ft Jon Boat with a Mercury 15hp..I have only taken it on a small river and @ low speeds...Never had it wide open...today I took it on a different river where I was able to open it up for short runs...nothing to crazy..ran great..So then on the way back from taking this little...
  2. T

    Part 2

    So I got the extra money I needed to start working on my boat..i'm replacing the gibler bearing & all the boots, shift cable, water pump, trim censer...so I got the bearing out and 1st boot off...and its not looking so good...what is this that I spy? looks like some one tried to fix this b4...
  3. T

    Ready to buy Parts...

    I am looking to start getting the parts together for my 3.0L Mercruiser... I am looking to buy U joints, Bellows tubes, Gimbal bearing...
  4. T

    ::Mercruiser Tools:: Sticky?

    I have not been on the forum long..but see a lot of people asking a lot of the same questions...I am a DIY guy and am all ways looking for info on doing my own stuff..one of the questions I have is...does any one have a NEEDED Tool list for working on the Mercruiser out drives...might be a good...
  5. T

    Gimbal bearing or U joints ?

    I am new to the page...I just have a question... How can you tell the difference from the gimbal & u joints?... when I took my boat out I had noise all the time..not just from turning.. thanxs for any help...-Paul
See more
Top