Recent content by tr@v1s

  1. T

    Mercruiser 3.0 won't "lock in"

    I was thinking I would go ahead and do bellows and gimbal bearing while in there. I assumed the same about the alignment, so I figure best to just knock all that out while I have the unit out. Got good numbers for those and the puller/install tool for the gimbal bearing?
  2. T

    Mercruiser 3.0 won't "lock in"

    Thanks Kenny!
  3. T

    Mercruiser 3.0 won't "lock in"

    Can anyone help me locate a part number number and vendor for the motor coupler? Recommendations on process/steps? Any other things I should definitely do while im replacing the coupler?
  4. T

    Mercruiser 3.0 won't "lock in"

    What do you mean by 'the vertical shaft'? The drive shaft to the lower unit? Pretty sure everything in the drive is good. You can see in the video I posted me turning the prop with it in gear and the shaft going into the motor coupler spinning without the motor coupler spinning. Am I not...
  5. T

    Mercruiser 3.0 won't "lock in"

    Question now: Pull motor, pull out drive, or pull both? (I'd like to be on the water next weekend if possible, but also want to do it right.)
  6. T

    Mercruiser 3.0 won't "lock in"

    Good news: adjustment worked. Bad news: Started motor to test shifting with motor running after verifying manually that the shift was locking in on the clutch dog and the motor was not turning the outdrive shaft. Assuming I have a trashed motor coupler... 🫩🫩🫩
  7. T

    Mercruiser 3.0 won't "lock in"

    Thank you dodge!! My shift plate is a different style than what is shown in the video. I assume the process is still the same? If the console cable has more than the specified 3" (+/- 1/8"), I assume that means the cable has to be replaced? What about the locking nut that locks the tube to the...
  8. T

    Mercruiser 3.0 won't "lock in"

    Thanks kenny. I can't seem to find it. Do you happen to have the link?
  9. T

    Mercruiser 3.0 won't "lock in"

    Hey all. Haven't been doing anything with boating for about 12 years. I used to be on iboats forum back then and messed around with little boats and old OMC outboards. I don't have the old email I used then to access that account, so started a new one. I have just purchased a 1989 28' Harris...
See more
Top