Recent content by trent0416

  1. T

    2002 MERCURY 90HP 2 STROKE EXHAUST SOUND ISSUE

    SO I WAS HEADING IN THIS EVENING OFF THE RIVER, AND THE BOAT OUT OF THE BLUE ACTED LIKE I HIT SOMETHING UNDER THE WATER. IT SEEMED TO REV A BIT AND MADE A NOISE, SO I BACKED OFF THE THROTTLE AND STARTED AGAIN. EVERYTHING WAS OPERATING FINE AFTER THAT, BUT WHEN I GOT INTO THE MARINA NO WAKE AREA...
  2. T

    Several issues and now no start 1998 elpto mariner bigfoot 2 stroke 60 hp

    Hello everyone and thanks in advance for any and all help: Working with 1998 elpto mariner 60hp 2 stroke bigfoot serial number og696921 on a 20ft monark pontoon the other night on the river and all was fine, stopped and floated for about a half hour or so and went to leave. Engine seemed to...
  3. T

    tach & trim gauge issues 1997 mariner 60hp bigfoot

    hello everyone. first off my tach on my 1997 monark sunspa 200 pontoon / 1997 60hp mariner bigfoot didnt work. i needed to see my rpms as i think my prop is oversized. i bought a new gauge set and installed. after install the tach registered and moved unlike the old one, the trim gauge was still...
  4. T

    1997 mariner 60hp bigfoot rpm and prop questions

    hello all. i have a 1997 60hp 2 stroke bigfoot on my 20 foot pontoon, and a main issue is the rpm gauge does not work, thus not allowing me to monitor proper rpm, but this boat is a dog loaded or empty. first i need information on where my proper rpms should be for this motor, and is there any...
  5. T

    1997 mariner 60hp bigfoot rpm and prop questions

    hello all. i have a 1997 60hp 2 stroke bigfoot on my 20 foot pontoon, and a main issue is the rpm gauge does not work, thus not allowing me to monitor proper rpm, but this boat is a dog loaded or empty. first i need information on where my proper rpms should be for this motor, and is there any...
  6. T

    1997 mariner 60hp bigfoot power trim issue

    hello. the power trim on my pontoon works, but when under load seems to fall on its own. any help? thanks
  7. T

    mercruiser 1989 454 getting no fuel to carb?

    i have a 1989 Cruisers Inc. Holiday 2570 with a 7.4L mercruiser engine. this boat was properly winterized and stored, but has not been run since 2007. when getting everything ready to go as the boat is for sale, it cranks over just fine, but when pumping the throttle for fuel, there is nothing...
  8. T

    1997 mariner 60hp bigfoot not pumping water

    i just bought this boat, and the first thing i noticed is it was not pumping water. i had a new water pump kit installed and seemed to be fine. slower water pumping at idle and better stream under higher rpm's. on my second day out i noticed i had a very light trickle at idle, and the same small...
  9. T

    1997 60hp mariner bigfoot questions

    sorry if i have dumb questions, but i am an experienced boater, but brand new to the pontoon boat world. i have a 1997 sunspa 200 - 20ft with a 60hp mariner bigfoot on it. i took it out on its maiden voyage last night and was slightly disappointed. as i know this will be no speed machine, it...
  10. T

    docking lights dim............help

    I have a 20ft sunspa that i just purchased and i have installed a pair of 55w halogen docking lights to the front. seems very simple..........ground, power, lead to lights switch and good. after my install if i have one light grounded it works to full power and perfect, the minute i ground the...
See more
Top