GOOD NEWS. . . . The PICTURE UPLOAD FUNCTION IS WORKING !!! The tech folks at the parent company have been able to remedy the issue. You can upload pictures once again. Thank you for your patience.
I have had a 1996 Bayliner Trophy 2002 with a Force 120 since it was new. My top speed is about 35 MPH at 5200 RPM trimmed. The RPM operating range according to Specs is 4750-5250, however I can get up to 5600+ but always throttle back in fear of doing damage by overreving the engine. I did see...
Re: Water mixed in gear oil on 96 Force 120
Thanks to both emoney and JerryJerry05 for your suggestions. Jerry I
drop the uint and drained the oil then I applied a little airpressure
and discovered a small leak around the shift pin seal. While I had it
off I picked up a new impellor kit. When I...
I notices gear oil dripping from the lower unit weep hole so I decided to change the oil and it was white. Replaced with new oil and after a day tubing the oil was white again. Are there common problems with these lower units? Does anyone have a recommendation?
I have done this many times before on Mercruiser and my Force Outboard. Am I missing something? I removed the 5 nuts that hold the lower unit in place but can't get the LU to seperate from the Upper Unit. I believe the rear stud/bolt is seized do to corrosion. The four outside studs have...
