Recent content by trumanlake

  1. T

    2000 Cruisers 3870 wiring

    Was wondering if anyone had the wiring diagrams or the wire harness drawings. Have downloaded the owners manual from Cruisers, but the drawings that were scanned are pretty much unreadable. Any help would be appreciated. Thanks in advance
  2. T

    info on 2000 Cruisers 3870

    Anyone have any information on 2000 Cruisers Yacht 3870? Looking at one now and was just wondering if anyone had any input about quality/problems. Thanks
  3. T

    93 Prima 243 seat upholstery

    Just finished reupholstering, and have good seat patterns
  4. T

    need a little assistance, please

    Have weathered another storm in Missouri but, the windshield and frame did not. Was wondering if anyone had any ideas on who the manufacturer was or where to get a replacement assembly. It is a 93 Wellcraft Prima 243. Have contacted Taylor, and they have no records back in that time frame...
  5. T

    Prima 243 questions

    Would like to compare notes with someone that has or had a Prima 243. Mine is a 1993. Was curious about what kind of prop and maybe RPM/MPH that you were getting. Thanks
  6. T

    inner transom plate question

    To start, Alpha 1 Gen 2 (transom 0F086629 eng 0F002022). Have looked through the installation document and have found no reference as to why the mounting holes in the inner transom plate are elongated (vertically). And do you just let the plate drop and rest on the bolts coming from the transom...
  7. T

    trying to remove swivel shaft

    This one may be for Don. Mercruiser Serial numbers to start: Transom# 0F086629 Drive# 0D876354. Doing some maintenance tryng to get ready for spring, ordered tools for various jobs. Have got to a point where it is time to remove the swivel shaft. The puller I was told I needed will not thread...
  8. T

    prop calculation

    hwsii after reading the other posts, I have gathered the information you will need I believe. Was wondering what kind of props the formula would come up with for, all round cruise, and top end, with this combination. 1993 Wellcraft cruiser dry wgt 4500 lbs, 60 gal fuel cap, 22 gal water cap...
  9. T

    1979 Catalina 281

    Twin 305's, curious as to the idle speed setting?
  10. T

    another alignment question

    We purchased a 93' Wellcraft w/5.7 Mercruiser Alpha 1 Gen II last year. Pulled the drive (no problem at all with removing, slid right out) over the winter to check things over and to replace impeller. Ordered alignment tool, and found the alignment off ever so slightly. Takes a little nudge to...
  11. T

    1997 Johnson 90 hp J90TSLEUA

    Was wondering if anyone would know what the head bolt, and water jacket cover bolt torque specs are. Manual is on order but going to be awhile, and it is ready to go back together. Thanks in advance.
  12. T

    temp sensor V6

    Just wondering if anyone know for sure which sensor is used on a 85 200hp ser#6625329. the Clymer manual says that there is two, one is <br />15 1/2" long which is a 240 degree and the other is 18 1/2" long and is 190 degree. The manual says that the 240 is the one that is mounted below #1...
  13. T

    back to this warning module

    I have 1985 merc 200hp ser# 6625329. Have had the same problems everyone else has had. Intermittent beeping hit it, it quits. Replaced module, idled past no wake bouys gave it the gas, about an 1/8 mile later, here we go again, beep,beep,beep.... I understand it compares the signal from the...
See more
Top