Recent content by Tucker1968

  1. T

    Rehab SportCraft 222 1983 deep V hull cuddy walkaround

    So PL is different than PL400 the construction adhesive?
  2. T

    Rehab SportCraft 222 1983 deep V hull cuddy walkaround

    Thanks for posting this. I recently learned what PB stands for and what products are required to make it. What does PL stand for? I (like many others) are trying to learn the lingo so I can understand process.
  3. T

    Advice on transom , stringers and floor rebuild

    Thank you, Myself and I'm sure many others are trying to learn the the lingo. I read lots of posts on here that have verbiage that I try and decipher.
  4. T

    Advice on transom , stringers and floor rebuild

    So it's three ingredients? Resin chopped up fiberglass fibers and this Cabosil?
  5. T

    New member, old boat question.

    The engine hatch will remain. I was thinking of going the epoxy route. I just wasn't sure it was feasible. I like details and contrasts and am not above showing off my work at at a local show. Thanks for your reply.
  6. T

    New member, old boat question.

    Hello all, new member, long time lurker. First I'd like to say I'm impressed with the knowledge on this forum. Very impressive. I'm not new to boats or boating. Bought my first boat at the age of 12 with paper route money. 12ft Aluminum Craft, 5 hp Mercury. Then came a Sea Raider 14ft 50...
  7. T

    outdrive swap ? alpha 1st gen what can i use ?

    Thank you gentlemen.
  8. T

    outdrive swap ? alpha 1st gen what can i use ?

    Hi Scott06, Here's what I have. Boat one, is a 87 Chris Craft Scorpion 210 with a frozen 5.7 and it's original Alpha One R drive. Looks exactly like the first photo Rick posted. Boat Two, is a 91 Baja Force 216 with a low hour (398 to be exact) and its original 350 Mag and Alpha One Gen 2...
  9. T

    outdrive swap ? alpha 1st gen what can i use ?

    Thank you.
  10. T

    outdrive swap ? alpha 1st gen what can i use ?

    Rick, are both generations just as tough?
See more
Top