90 welcraft mercruiser alpha one Gen one has hydrofoil skaggaurd on it. When going down lake when water is rough or hit someone else wake almost loose control of boat. Feel like it about to top have to back throttle all the way back. Also sometimes when taking off it will lean to one side or the...
On my 90 welcraft mercruiser 4.3 v6 the tank is in the floor there is a green wire that comes out under carpet near bilge out. My fuel gauge don't work this wire is just laying there not hooked up. Does the wire need to go to power or is it ground. Also near the right side of manifold I have a...
My prop on my 90 mercruiser alpha one Gen one has a prop lock. Once I get the prop lock off where can I get just the nut go on it. An what size. None of the boat stores around me have a prop lock kit to remove it. I read where you can use a screwdriver get the lock off just don't know be able to...
Can someone point me right direction I'm ordering a impeller. Not sure what gen out drive have. It's a mercruiser alpha 1 there is only two bolts on back side of the lower unit where the propeller is.
First question is first time putting in water after flywheel change, soon as pull from dock the temp gauge is raising at idle an low rpm. Running almost max on temp gauge but soon as you throttle up keep high rpm it runs 180. Don't know the actual name of part but the tubes coming off the...
I need to replace flywheel on my 90 welcraft mercruiser 4.3 v6 no fuel injection. Where can I get one. Can you use a automotive flywheel on these motors. New to the website I hope ok to post here.
