Recent content by videorov

  1. V

    Prime bulb not pumping up hard

    When I pump the prime bulb going to the Yamaha<br />150 OX66 Saltwater series it never get firm.<br />My other motor is the same and the prime bulb<br />pumps like it should.<br />I took the drain plug out of the vapor separator tank and pump the bulb and fuel comes out like the book says it...
  2. V

    Superimpose Furuno 1712 over Marine Navigator in laptop?

    Wonder if there is a way to do this? I have Marine Navigator on my laptop and also have a Furuno 1712 radar. Just wonder if there might be<br />a way to combine them like some of the new<br />units on the market.
  3. V

    Installing 4 batteries for two engines 150hp

    Going to install four batteries with switches<br />to switch pairs of them in and out. Keep pair<br />for motors and pair for electronics and two bait<br />wells. Want to be able to charge either pair from engines. Dual engines here.<br />Im going to also put two extra batteries in<br />center...
  4. V

    Installing 4 batteries need wiring diagram

    Going to install four batteries with switches<br />to switch pairs of them in and out. Keep pair<br />for motors and pair for electronics and two bait<br />wells. Want to be able to charge either pair from engines. Dual engines here.<br />Im going to also put two extra batteries in<br />center...
  5. V

    Has anyone seen a Baha 250 Fishkeeler

    Its an inboard with motor in the mid section.<br />It has a real deep Vee haul and has lots of room to work around the engine and get to the fuel tanks. Its easy to see and work on the drive shaft and the sterring linkage.<br />Lots of room in back NO hump for motor needed so<br />nice place to...
  6. V

    Who make a good engine stand for merc 7.4 mpi

    I would like to buy a good engine stand that will hold my Merc 7.4 MPI engine. I like the 4 wheel models. Anyone know of a good one out there?
  7. V

    Who make a heavy duty motor stand for Merc 7.4 mpi engine

    I would like to put this enging on a motor stand<br />if I can find a good one. Ive seen some four wheel types on Harbor freight.<br />Its a heavy engine. I want to be sure and get the right one that will bolt to the block right.
  8. V

    Taking rusted manifolds off Merc 7.4

    The bolts are rusted, spark plugs rusted. Need<br />to get the manifolds off and spark plugs out?<br />Any ideas on tools needed to do the Job and<br />the way to do it?<br />Im going to put stainless risers back and aluminum manifolds with closed water system.<br />The motor is around 2 years...
See more
Top