On my pontoon boat I have 1/2" plastic plugs at the bottom to drain any water from them. I need to replace them as one is cracked. I know I can't put stainless or galvanized one in there as it will react with the aluminum. Can I put either brass or bronze ones in without creating a problem...
I have a 94 Johnson 48HP that is giving me some problems. After trolling or idling for about 10 minutes or so (sometimes less), when I go to throttle up, the motor will not run above 3000 rpm. It seems like it is bogging down. This also happens sometimes when I am just running along at full...
I am looking into filling the pontoons on my boat with Polyurethane expanding pouring foam. The questions I have are as follows: Has anyone ever done this before?? How can I figure out how much foam I will need? Any suggestions or ideas on how to get the stuff in there would be appreciated...
Just got a boat with a Johnson 48 and have some questions. I am new to boating so any help would be GREATLY appreciated.<br /><br />The model number is J48ESLERD. I know the J is for Johnson, the 48 is for the horsepower, what does the rest mean??<br /><br />I have dual 12 gal removable tanks...
What are the idle settings on a 96 Johnson 48? Also what is the proper idle RPM? Just bought the boat and it has been sitting for a couple years. Seems to run pretty good except for the fact that it does not like to idle. Any other ideas on what I should check, clean on the engine?? THANKS!
