Have you pulled the flywheel and checked your points? When you pull the Flywheel, post a Pic of the points. If you need help pulling the Flywheel search Wickware in the site and you should find Pics and notes. The Clymer Chrysler/Force Outboard Shop Manual was very helpful with Specs and...
Where are The Old 35HP Chrysler users? I have enjoyed this Site and learned so much and enjoyed sharing what I learned and tested. I slowed due to challenges and it appeared Old 35HP – 55HP Chrysler users slowed as I did. I still checked the site weekly until I could not get in. There was no...
Did all of us ?Old 35 HP Chrysler Engine Lovers ?? Health or Etc fail about the same time? The Site seems to have gone blank on issues and support. I or we realized our need to evaluate issues in 2014. We were having too many answered issued on and off the water vs boat issues.
We shut our...
Are there repairs for 1/4 " plastic coated steering cables? My 1968 Ray Craft?s steering cable, Fuel Line and Rear Trailer light?s lens got sun damaged (from not enough tarp converge from ?Late Evening?s Texas Sun). Under a tree and a tarp there was a window of sun not noticed coming in an...
SeaStar69, please try and post you picture again. I feel you are referring to ?Static Timing? that we used to time VW engines 60s-70s. I have a 1970 35HP Chrysler that I purchased in 1984. I have not had a timing issue ?One Time?. It has always been dirty points that caused some hesitation...
0n my 1970 35HP Chrysler there is a clamp that clamps over a bar that will hold the motor down. It will also let the motor slip past the bar if the motor hit a stump or Etc hard enough. For tilting/loading purposes there is a knob under the motor that you pull to release the clamp. Zoom the...
Will Mothballs or What keep rats/rodents out of my stored boat? 03-06 we did not fish due to a drought and rats damaged life jackets and made messes. I tried to rat proof my Boat?s Storage Box. Today I noticed they got in, damaged life jackets and left their filth. I left too much clearance...
Post parts diagram or post good close pictures from the area where the motor is clamped to boat. Item 66 on the diagram attached might be the pin/rod needed. Post a pic of your motor in that general area.
Is Frank OK! (((( Unfortunate Update Regarding Valuable iboats Member Frank Acampora :( ))))
Is Frank OK! I noticed others have wondered also. I feel Jerry would be the person to know why Frank has not posted in a about 3 weeks.
No Title
Post a picture of your setup. This is mine posted of 1970 35 HP Chrysler. I purchased the boat and engine used in 1984-85. I changed points/condenser out of old habits (form cars). I doubt they were bad (pitted) since the motor ran well (or slight hesitation that cleaning points...
If it was shifting before you dropped the lower unit it should be shifting if you start the coupling on both rods to center the process of F-N-R. As mentioned, if you are adding new cables you might have a number of adjustments to make (control Box, Engine and Etc).
On my 70 1970 35HP...
Is Rack & Pinion part (Morse # b305083 132) fairly easy to find online vs a kit?
Is this Rack & Pinion part (Morse # b305083 132) attached fairly easy to find online vs a kit? If so where would be a good source online? I hope this is enough info and good info as I am trying to help a friend...
What would cause me to not have my log-in option vs a join option ?using Internet Explorer? (where My Favorites are listed)? I am a member when I attempt to join. I have asked this question at Contact Us with no reply. Has anyone else experienced this and what was the Fix? I can see all the...
