My brother-in-law has a 1992 3 cyl 60 HP Johnson. His tach has stopped working properly. It works fine at 1000-3000rpm, but will not go any higher. I checked the voltage at idle speed and it was about 13v. At 1500rpm it was 13.5v. Am I correct that the rectifier is working properly? What...
I have just finished rebuilding the FasTrak trim unit on my Evinrude 225. Put on a new pump motor and full seal kit. Everything went back together great...took a little while to bleed most of the air out so the motor would go up and down. All in all it is working great, however I have a loud...
Well I have the FASTRAK unit off the motor, amazingly no torch was needed, just a few good licks on a big punch by a 3 lb hammer. I have a good shop manual and parts ordered, but I cannot get the end cap out of the tilt or the trim cylinders. The manual calls for a universal spanner wrench...
