How much should it cost to repair a stainless prop? How do they fix it, just pound it out? The damage is a bend about the size of a dime and about 1/8th out of alignment.
I'm new to high performance bass boats. I have a new to me 1994 basscat with a Evinrude 150 intruder on a 5 inch manual jackplate turning a 13-3/4x25 Renegade prop at 5100 rpm giving me 51 mph GPS. The prop shaft is set at 4-1/4 inches below the bottom of the boat (used a laser level, works...
I don't see an air filter in my 1986 johnson 120 but logically it should be in the cowling. Internet searches turn nothing up. I don't have a manaul becaues I have learned I always try to do more than I should so stuff gets broke (expensive stuff) instead of fixed. Can't stand the temptation I...
I'm weak on my motor knowledge and only know enough to do very basic stuff. I decarbed with seafoam since it sounded easy enough and after following directins and letting it set for an hour I went started engine on muffs and the best way I can describe it is it ran irregularly. How do you type a...
Just had boat out for 2nd time this year. I've been doing some restoration. 1986 Johnson 120 with the VRO disconnected and oil mixed in fuel. I picked up an intermittent short chirp/buzzer. This is at low speed on a no wake lake running 800-1200 rpm. No ater temp gauge but water from engine...
I only know enough to be dangerous. The local prop guy doesn't allow testing a prop before buying so I have to have a pretty good idea when I start out. I have a 1986 Johnson 120 hp and have the a prop that came with the boat plus one that I bought and have had repitched. The orignal is a...
I only know enough to be dangerous. The local prop guy doesn't allow testing a prop before buying so I have to have a pretty good idea when I start out. I have a 1986 Johnson 120 hp and have the a prop that came with the boat plus one that I bought and have had repitched. The orignal is a...
I have a 1986 Johnson 120 that idles fine but from 1000 - 2300 rpm it runs rough then it smooths back out as soon as RPMs get over 2300.<br /><br />Where should I start?
I have an 86 johnson 120hp that is running strangely. It revs up for a half second stops almost dies and then revs again. Could this be a bad power pack?
