i have a yamaha 225 3.1 l ox66 2001 it idels rough and sometimes dies when shifted into gear when punched to take off it will not get over 1500 to 1800 rpm if you play with trim and raise up high it will get enough rpm to plane but have to trim down in a hurry i had the vst cleaned 02 sensor...
i have a question when you shift into gear is the lever on the switch suppose to close and then open in netural i checked the switch with a dvm the switch seems to work but linckage does not move the lever on switch and would this be causeing my power loss under load at takeoff "thanks for your...
i have a yamaha 3.1 225 2001 model vx225tlrz i had it rebuilt when a cylender over heated since rebuilt it boggs at hole shot sometimes you can trim motor all the way up and get enough rpms to plane out runs good after planeing out but come back to idle it boggs again i had a crank position code...
