Alpha 1 Gen 1 Outdrive installation issue-shaft too high

R

Rhadley

Petty Officer 1st Class
Joined
Jul 20, 2003
Messages
237
I am trying to put the outdrive back on after replacing the lower and upper shift shafts. The lower shift shaft is hitting the bottom of the bell housing, as if it is sticking up too far. Tried to tap it down into the lower unit but it does not move. Any ideas how to get it to clear the bell housing?
Thanks.
 
Scott06

Scott06

Admiral
Joined
Apr 20, 2014
Messages
7,237
Rhadley said:
I am trying to put the outdrive back on after replacing the lower and upper shift shafts. The lower shift shaft is hitting the bottom of the bell housing, as if it is sticking up too far. Tried to tap it down into the lower unit but it does not move. Any ideas how to get it to clear the bell housing?
Thanks.
Click to expand...
Is the washer holding it onto lower in right location ? Take a pic of what you have going on.
 
You must log in or register to reply here.
Top