Search results

  1. M

    furuno radar 1900 open aray wiring diagram

    hi i have a furuno 1900 with a open array, system works and array goes around but doesnt recieve signal i notice that theres three wires cut from when it was remove and i believe those are for the signal does anyone have a diagram for this for if csomeone can tell me where to hook up those 3...
  2. M

    1986 volvo tamd 70c how many hours

    hi im looking into purchaseing a tamd 70c for my bost the one i found has 9500hrs on it can some one tell me how many hours are these volvo diesels able to run up to
  3. M

    volvo tmd40a prop

    hi i need to know what size prop with what pitch is needed for this motor with 280 outdrive i have the motor in a 2000 seaswirl stripper 2600 and i gett the motor wot at 3000 rpms but cant get the boat to plain out please let me know thanks
  4. M

    volvo penta tmd40a acceleration problem

    hi i just had a tamd40 installed in my boat but the guy that instaleed it did a terrible job now i went to go try it out on the bay and it doesnt rev up more than 1700 rmps and i had to hook up an electric fuel pump to the mechanical fuel pump because with only the mechanical one it would die...
  5. M

    1990 omc 5.7 thermostat

    hi can any one tell me what degree thermostat i need for this motor because i have 2 different manuals for this motor and one says that the standard is 140 and the other says 160 but i put a 160 on my motor and the gauge says 3/4 hot and ive changed everything on it water pump raw water pump...
  6. M

    1990 omc 5.7 temp problems

    i have a 1990 omc 5.7 and i have already had the heads rebuilt put in a new thermostat changed the temp sensor and impellor and waterpump for the motor and after it warms up im getting a reading on my gauge of 3/4 hot at idle and it does not move from there can any one tell me what this can be...
  7. M

    1990 johson 100hp comercial v4

    hi im wondering if anyone has a engine schematic of this motor and specs
  8. M

    acceleration problems

    hi i have a 1990 johnson 100hp commercial vro outboard and the past two times i have gone out with it its been giving me problems it starts up fine idles good takes off with no problems but when i fully accelerate it it runs good for about 2 mins then it slows down for acouple of mins then picks...
Top