Search results

  1. C

    1973 6HP Evinrude Broken Pinion Gear

    I transported the motor from NY to FL to find out when I got to FL that the Pinion Gear broke in 1/2. Right where the Roll pin slot is. Therefore I have nothing engaging the flywheel to start the motor. The Starter rope, when pulled, coils back perfectly. <br />Does anyone know if this is a hard...
  2. C

    1988 225 Evinrude Running Rough at Low speeds

    Went out for a ride yesterday where my engine was running fine at 3200 RPM. (Never ran it over that since I had the motor...1000+ Hours). Stopped at the fishing hole for a while, then I started it and went up to 3200RPM, it would stay there for around a minute then go up to 3300. I would try to...
  3. C

    1988 225 Evinrude Running Rough at Low speeds

    Went out for a ride yesterday where my engine was running fine at 3200 RPM. (Never ran it over that since I had the motor...1000+ Hours). Stopped at the fishing hole for a while, then I started it and went up to 3200RPM, it would stay there for around a minute then go up to 3300. I would try to...
  4. C

    1988 225 Evinrude Running Rough Below 5 Knots

    Went out for a ride yesterday where my engine was running fine at 3200 RPM. (Never ran it over that since I had the motor...1000+ Hours). Stopped at the fishing hole for a while, then I started it and went up to 3200RPM, it would stay there for around a minute then go up to 3300. I would try to...
  5. C

    1972 6HP Evinrude Leaking Lower Unit Lube

    I have a 1972 Evinrude which is leaking lower unit oil out from one of the 2 philip head screws a little above the skeg. There is no oil leaking from either flat head screws where I put fluid in, and the vent. Does anyone know what these "philip head screws" are holding or if this is a big...
  6. C

    Garmin Antenna Installation -- HELP

    I tried to fish the antenna wire with connector (on a 182) through my hardtop to the electronics box. However, when I pulled out the antenna cable at the electronics box, the cable was shredded. The connector is still on but around an inch after the connector, the wire is shredded and the metal...
  7. C

    Gas Flowing out of Carbs when idling

    I have a 1988 225 Evinrude. The boat runs fine when it over 1 or 2 knots. When I go any lower or in neutral it will cough, and stall, then gas begins to come out of the cowling. Does anyone have any experience with this kind of problem?<br /><br />Any advice would greatly be appreciated.
Top