Search results

  1. K

    1975 Cobalt Prop Info needed

    I have a 1975 Cobalt 16' tri haul in need of a prop. Here is what I know. The boat weighs 2,350 lbs. The prop that just broke has no identifiable numbers on it. I downloaded from the Cobalt website this info. There are 2 props recommended, one for Heavy loads and one for Light loads. The...
  2. K

    1955 Big Twin Water Pump Problem

    My motor is not pumping water. I had it running fine last year and wanted to take it out for the first time this week. Put it in a barrel and started right up but no water coming out. I took the lower unit off thinking the impeller might have been bad but it looks fine. ( I replaced it last...
  3. K

    Pressurized Tank

    I have an evenrude pressurized gas tank I am trying to take the two washers out of the connection from the tank to the motor. I have been pushing down on the spring with a nail and trying to scrape out the washers with a knife but can't seem to get them out. I dont want to ruin anything so I...
  4. K

    1955 Evinrude Magneto Wire

    I have a 1955 Evinrude Big Twin 25. We are in the last stages of a total rebuild and have a question on the Magneto. There are 3 wires comming from the Magneto. Two spark plug wires and the third looks like some kind of ground but we do not know where it goes. Can someone please tell me what...
  5. K

    1955 Big Twin 25 Rebuild

    I am doing a total rebuild on this motor and have a few questions. They are as follows: 1) Since I don't have a parts motor, if I am inquiring about used parts can I use any other Evinrude motor or am I limited only to a 1955 BT 25? I will list what I am looking for below in case anybody has...
  6. K

    1955 Evinrude Big Twin 25

    Re: 1955 Evinrude Big Twin 25 Here are the pictures. If these are grease fittings, is it normal to see the black sludge come out of them? Do I need to shoot them full of grease and what kind of grease? Thanks again for the help.
  7. K

    1955 Evinrude Big Twin 25

    I have a 1955 Evinrude 25. You guys have been a great help in getting this motor running and I have used it a lot this summer. My question now is there is black sludge comming out from what looks like small grease fittings under the motor. At first I thought that it was old oil and sludge...
  8. K

    1960 Sears Trailer

    I have a 1960 Sears Elgin Boat Trailer model #254-61500. I use it to carry a 1960 aluminum Starcraft fishing boat. The problem is it has the original rims which have only 1 lug nut. The rims have the bearings packed inside of them. Because of rust I need to replace them and nobody I have...
  9. K

    1955 big twin 25 Exhaust Loading Tube Assembly

    When I took the lower unit off, the Exhaust Loading Tube Assembly (Part #376330) fell out of the upper unit onto the garage floor. I had no idea where it came from until I got a parts list which shows it being part of the Power Head (I think) and it shows it being screwed in from the top. What...
Top