Search results

  1. M

    Merry Fisher 695 - change of prop did the trick

    Just for info - have a Merry Fisher 695 with Volvo Penta 105hp to a 3 blade 19" 15pitch prop - on a good day max speed 10-12kts @ 4000rpm Contacted Clements Marine http://www.clementsmarine.co.uk/home/ Supplied the make/model/hull no - engine and gearbox ratio. ?600 later - new prop - 3...
  2. M

    Refill hydraulic oil on PTT unit

    Hi, I have fitted a new PTT motor, but am unsure how to refill pump unit with hydraulic fluid. So far I have manually pumped the ram up and down around 4-5 times and filled with fluid, shut off manual release screw, raised and refilled. I must have entered approx 24 fl ounces. Whole unit...
  3. M

    Refill PTT fluid

    Hi, I have a new PTT motor on order, but before fitting I would like to drain exisiting hydraulic fluid an replace. As a newbie to PTT motors can you advise what fluid I should install in Yamaha 50HP 62F L 500xxx 1993. I read on earlier posts that there is a PTT fluid filling point somewhere...
  4. M

    Power trim and tilt motor

    Hi, I have a 1989 Yamaha 2 stroke 3 cyl 50hp motor with Power Trim and Tilt. I think the PTT motor is near end of life. When I press the button to raise or lower I just get a clicking , I have checked input voltage and thats good. When I tap the motor with a small hammer the motor starts...
  5. M

    Yamaha 40 - 45 Deg spray

    Hi, I have an old 1986 Yam 3cyl Long shaft 40hp 2Stroke that sprays out a lot of 45 degree water when travelling over 15 knots. Transom height is 21 inches. I have been told I need to change the angle of the motor in relationship to the transom, others have said the prop is too deep. Any ideas...
Top