Search results

  1. drtyTshrt

    I want to swap Mercury 200 hp 2.4 EFI to carbs.

    The ECU is dead. Sn C126437 Can I get some direction to track down parts and part numbers to do this swap? I believe it is going to be a good bit of details but I and just getting started. I have horizontal reed blocks if I remember correctly. I would like to buy the parts needed or a parts...
  2. drtyTshrt

    Compression numbers

    I have head gaskets on order. I hope that to be the case of a overheat at idle condition I have been chasing. I had 118 PSI across the board when I bought the motor. I have beached it and tried to carry it back with me once but I never have had many buzzers and always at idle. The pee hole...
  3. drtyTshrt

    What is this valve plug for?

    [/URL][/IMG] [/URL][/IMG] My motor info is in my sig. The oil injection has been removed. This screw in one way valve is just pluged with a bolt and leaks fuel. Can I install a brass plug in its place? What was/is it. It is at the bottom on the right side of the motor.
  4. drtyTshrt

    what is the gunk coating my coil connections

    I am replacing spark plug wires and there is a thick green coating on the connector at the end of the wire at the coil. Should I clean inside the coil connection? What is this gunk and where did it come from? Must be oxidation. I'm gonna clean it out of there.
  5. drtyTshrt

    I am missing my rectifier

    My battery is not charging while the motor is under power. I did the search and determined it to be my rectifier because I co\rossed the battery wire one time. I bought the Radio Shack part and came home to install it and lo & behold it is missin. I read where the old man said to toss it or the...
  6. drtyTshrt

    Trim Motor

    The three wires coming from the trim motor,Green, Blue, Black. Is the Black a ground or does it connect to the starter soleniod? My trim motor has been tempermental so I decided to clean the contacts on the solenoids. Long story short I replaced the two starter solenoids and my trim motor still...
  7. drtyTshrt

    fuel/filter water/seperator with sensor

    What does the sensor sense? Mercury Marine 35-18458Q3 replacement parts - iboats
  8. drtyTshrt

    Fuel filter over kill?

    Is there such a thing as too any fuel filters? I have one just out of the tank in line. Then the fuel/water seperator. Then there is a small in line under the cowl. This is a 1989 200 EFI Merc. I thought about putting a fine mesh screen inside the tank on the pick up tube as well. All of the...
  9. drtyTshrt

    gear shaft

    I was changing the water pump today and the long gear shaft broke at the spline. I looked up what I think is the part. 1989 200 Black Max. Please tell me this part is not $850.00. I already have it out from the little roll pin in the cowl and pulled it out from the bottom.
  10. drtyTshrt

    Fuel Tank

    I need to acces my fuel tank.Can I just take out the screws from the floor panel and slide it back? Do I need to take the screws out of the helm as well? 1989 20ft center/console SeaCraft Tracker.
  11. drtyTshrt

    Steering cable length

    My boat is a 20ft SeaCraft C/C. My steering cable needs to be replaced. Can you good people recomend a steering cable length? I have a Teleflex SafeT helm. I do not have the cable out but I want to go ahead and order it. I am also having trouble up loading jpeg files from my computer. Is there...
  12. drtyTshrt

    1989 s/n c126437

    The cowling says it is fuel injected. I believe it to be carbed. I can see 4 butterflies in the breather box. Can someone shed some light on my motor? This is the first Mercury I have owned. It is also a one piece cowl not split.
Top